I was looking for lightweight tool which would help me with troubleshooting multicast on VXLAN transport network (underlay). While both vCNS and NSX have built in tools (pings of various sizes and broadcast packets) I needed something more flexibile where I could do arbitrary IGMP joins and leaves.
I used CentOS VM with one interface directly on transport network and software SMCRoute. This link contains binary package that works on RHEL/CentOS. Some other notes:
- if you have multiple interfaces make sure the multicast is routed through the correct one:
route add -net 224.0.0.0 netmask 240.0.0.0 dev eth0 - I had to install also glibc package:
yum -y install glibc.i686
- Make sure the kernel supports multicast
cat /boot/config-<kernel version> | grep CONFIG_IP_MULTICAST
- Enable ICMP ECHO on broadcast/multicast
sysctl net.ipv4.icmp_echo_ignore_broadcasts=0
- Start the smcroute daemon first:
smcroute -d
To join and leave a multicast group use -j and -l commands:
smcroute -j eth0 239.0.0.1
smcroute -l eth0 239.0.0.1
To check current memberships use:
netstat -ng
or
ip maddr
IGMP version can be changed with following command:
echo “2” > /proc/sys/net/ipv4/conf/eth0/force_igmp_version
Additional useful statistics about IGMP joins:
cat /proc/net/igmp
To see which hosts are member of particular IGMP group just ping it and see who replies:
[root@CentOS~]# ping 239.1.0.10
PING 239.1.0.10 (239.1.0.10) 56(84) bytes of data.
64 bytes from 1.1.0.1: icmp_seq=1 ttl=64 time=0.141 ms
64 bytes from 1.1.0.3: icmp_seq=1 ttl=64 time=0.256 ms (DUP!)
Hosts 1.1.0.1 and 1.1.0.3 replied to ping on 239.1.0.10 multicast group.
